![]() ![]() Use a personal fall arrest system or guardrail system to prevent workers from falling from all open sides and ends of the scaffold, aside from the side next to the wall being laid.A guardrail system that is built within nine and a half inches of and along at least one side of the walkway must be installed to safeguard any walkway inside of a scaffold.Both systems must have a minimum 200-pound top rail capacity. When the platform is supported by the frame structure of a self-contained adjustable scaffold, it must be protected by a guardrail system, and when the platform is supported by ropes, it must be protected by both a personal fall arrest system and a guardrail system.On a single-point or two-point adjustable suspension scaffold, a personal fall arrest system and a guardrail system are required for protection.A personal fall arrest device must be used to prevent falls when working on a boatswains’ chair, catenary scaffold, float scaffold, needle beam scaffold, or ladder jack scaffold.Because scaffolds are temporary structures built to assist workers who are building or dismantling other structures, and because scaffolds are less suitable for the use of fall protection at the time the first level is created, different thresholds are needed.ĭepending on the kind of scaffold, several types of fall protection should be offered to the personnel: Though some regulations mandate the use of fall protection at six feet for the majority of building operations, the threshold for scaffolding operations is different. The maximum planned load, the load-carrying capacity of the scaffolds utilized, and any additional requirements that may be relevant.Įvery worker on a scaffold more than 10 feet above a lower level requires protection against falling.Potential electrical and fall risks in the work environment.Proper methods for handling electrical risks, as well as for setting up, maintaining, and taking apart the employed fall safety and falling object protection systems.Training such as our own train the trainer Scaffolding Certification Safety Training Course must include knowledge of: Each employee who works on a scaffold must be trained by a certified trainer to understand the risks and how to reduce or mitigate them. OSHA tightened the training standards to stop this from happening again. In 1996, The Bureau of Labor Statistics (BLS) investigations revealed that 25% of employees hurt in scaffold accidents had not received scaffold safety training. Working on or around scaffolding is safer thanks to OSHA’s construction scaffolding regulations. Workplace safety is at risk from dangerous scenarios including falls, flying objects, and unstable structures. Use a debris net, catch platform or similar structure where appropriate to catch falling objects.Scaffolding, on its own, makes a work environment unsafe at a construction site.Tie or brace the scaffold to a solid structure as appropriate.Do not use nails or other devices in the place of proper retention parts as recommended by the manufacturer.Use coupling devices to join frames to prevent the joints from pulling apart.Level the scaffold until a proper fit can be made easily. This bracing is often attached to the point where the scaffold is tied to the structure. Install horizontal bracing at the joint of every third tier of frames. Brace both sides of every frame for the vertical plane.Thawing soil can become water-soaked and lose its ability to bear weight. Take extra precautions when erecting scaffold on frozen ground.They allow for minor adjustments to help keep scaffold plumb and level. Install scaffold with jackscrews (adjusting screws).Sills should extend at least 610 mm (2 feet) beyond the scaffold base and be long enough to extend under at least two scaffold feet. Set scaffold feet centrally on mudsills consisting of 50x250 mm (2x10 inches) planks.You are here: Platforms - Frame Scaffold Components ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |